N06C2
Session: Jun 2006 (session 2)
Wavelength: 6 cm
Comment
To give feedback on this experiment, click
Experiment Feedback
Arecibo (T Ghosh at Sat Jun 17 09:07:34 2006) Success :
All went fine.
Onsala (Michael Lindqvist at Sat Jun 17 10:25:24 2006) Success :
No known problems.
Shanghai (Tao An at Sat Jun 17 10:56:23 2006) Success :
All systems are normal.
Noto (P. Cassaro at Sat Jun 17 12:37:54 2006) Success :
Urumqi (Zhang Hua at Sat Jun 17 13:28:39 2006) Success :
Effelsberg (dgraham at Sat Jun 17 13:28:41 2006) Minor failures : RECO
Bad mk5 crash during disk2file at 07:57, operation restored at 08:54 .
Otherwise OK.
Torun (Kaz Borkowski at Mon Jun 19 06:29:58 2006) Success :
No known problems.
Hartebeesthoek (Jonathan Quick at Mon Jun 19 07:07:46 2006) Success :
No known problems
Westerbork (Tony Foley at Mon Jun 19 08:05:32 2006) Success :
Wb used in phased array mode.
no known problems
Effelsberg (A. Polatidis at Mon Jun 19 08:52:15 2006) Minor failures : RECO
Lost observations between 0800-0900 due to Mk5 problems
Jodrell_Bank (Alastair Gunn at Tue Jun 20 09:30:33 2006) Minor failures : ANT
The MkII telescope was used (Jb2).
Missed data between 07:05 and 07:24 UT due to antenna control problem. No other known problems.
Medicina (Andrea Orlati at Tue Jun 20 09:30:36 2006) Success :
All ok
Cambridge (Alastair Gunn at Tue Jun 20 09:31:02 2006) Success :
No known problems.
EVN experiment feedback facility: entire session
Entire Session
Session: Jun 2006 (session 2)
Wavelengths: 30cm 18/21 5 6 cm
Comment
To give feedback on this entire session, click
Entire Session Feedback
Torun (Kaz Borkowski at Mon Jun 5 12:32:29 2006) Minor failures :
This note concerns the UHF experiments only.
Shortly before the first experiment we could manage to install the Lange coupler to produce two circular polarizations instead of the linear polarization announced in the block schedule. Also, we failed to install the phase cal.
Jodrell_Bank (Alastair Gunn at Tue Jun 20 09:14:12 2006) Success : PCAL
The MkII telescope was used (Jb2).
During this session the Mk2 phase cal. signal was found to be too high and could not be easily reduced in strength. I therefore switched off the phas cal. signal for the entire session (for Mk2 only).